5 Expert Pool Cue Tip Replacement Ideas – How To Re-Tip A Pool Cue

November 6, 2020
Hero-Image
170
Views

A worn-out cue tip, especially before a match, is like one of those nightmares where you cannot wait for it to end. If your cue tip is worn out and you have a major match coming up around the corner, the chances are that you will go to your “cue tip guy” to get it re-tipped. Chances are there may not even be a “guy” in your locality at all. In any case, getting someone else to re-tip your pool cue is essentially splurging money unnecessarily. Especially if you can get the pool cue tip replacement or pool cue re-tipped by yourself, there is no need to indulge in any other unnecessary hassles of getting someone else to do
the job.

You can easily learn how to re-tip a pool cue and save yourself much-unrequited trouble in these five simple tips.

Removal of the old pool cue tip:

The old tip serves no purpose and has to be cut off, although you should proceed with utmost caution. Before a pool cue tip replacement, it is important to ensure no trace of old glue on top of the ferrule. It is important that you gouge out the ferrule and not the edges while prepping it. This
will ensure that the glue has a place to remain fixed.

Affixing the new tip:

It is essential that you are wearing your gloves properly to ensure you do not soil your fingers. The bottom of the tip must be scuffed so that the glue is held on in one place. A small portion of the glue is to be applied to the top of the ferrule and the bottom of the new cue tip. After applying the glue,
you must press the cue tip and the ferrule tightly against each other and hold that for about 5-10 minutes or so. After about 2-3 minutes, you can wipe the excess glue and ensure that the new tip stays on.

Prepping the tip:

It is important to be careful while removing the excess tip. For this, you have to cut and sand the cue tip to the ferrule. While cutting the cue tip, you have to make sure that it matches the ferrule’s diameter. The excess tip needs to be sanded with high grit sandpaper and finally round off.

Burnishing and conditioning:

Burnishing and conditioning the tip is very important, especially if you have to ensure a smooth finish. Burnishing helps the cue tip to hold its shape and gives it a smooth finish. Conditioning with burnishing is essential to close off all the wooden surface pores to prevent any entrance of dirt or oil.

Chalking:

Chalking is very essential to the entire process and is essentially an art. Chalking must be in such a manner that you rub the chalk across the tip. The foremost prohibition in this manner is to ensure that you do not grind it in the center and prevent the ferrule from getting stained.

The bottom line

Ultimately you must understand that the thumb rule while re-tipping is to maintain complete safety at all times. It is equally important to maintain a balance between the tip and the ferrule and not damage the ferrule during the process.

Leave a Reply

Your email address will not be published. Required fields are marked *